Honda CR-V: EGR Passage Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System / EGR Passage Removal and Installation

Removal

1. Drain the engine coolant.

2. Remove the air cleaner housing.

3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B).

Honda CR-V. Cooling System

4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C).

Honda CR-V. Cooling System

5. Remove the air cleaner housing brackets.

Honda CR-V. Cooling System

6. Disconnect the exhaust gas recirculation (EGR) valve connector.

7. Remove the EGR passage.

Honda CR-V. Cooling System

8. Remove the EGR valve.

Honda CR-V. Cooling System

Installation

1. Install the EGR valve (A) with a new gasket (B).

Honda CR-V. Cooling System

2. Install the EGR passage (A) with a new gasket (B).

Honda CR-V. Cooling System

3. Connect the EGR valve connector.

4. Install the air cleaner housing brackets.

Honda CR-V. Cooling System

5. Install the upper radiator hose (A), heater hose (B), and water bypass hose (C).

Honda CR-V. Cooling System

6. Install the harness holder bracket (A), then install the harness holder (B).

Honda CR-V. Cooling System

7. Install the air cleaner housing.

8. Refill the radiator with engine coolant, and bleed the air from the cooling system with the heater valve open (see step 6).

READ NEXT:

 Fan, Fan Motor, Shroud Removal and Installation

Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disconnect the fan motor connectors (A) and hood switch conn

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the co

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 E

SEE MORE:

 EVAP Canister Replacement

1. Lift the vehicle, and support it with jackstands. 2. Remove the cover (A). 3. Remove the EVAP canister baffle cover (A). 4. Disconnect the hoses (A) and the fuel subharness 6P connector (B). 5. Remove the bolts (C) and the EVAP canister bracket (D). 6. Remove the EVAP canister (A) from the E

 Towing Your Vehicle Behind a Motorhome

Your vehicle can be towed behind a motorhome at legal highway speeds up to 65 mph (100 km/h). Do not exceed 65 mph (100 km/h). Otherwise, severe transmission damage will occur. To avoid damage to the 4WD system, your vehicle must be towed with all four wheels on the ground (flat towin

© 2016-2025 Copyright www.hcrv.net