Honda CR-V: EGR Passage Removal and Installation
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B).
4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C).
5. Remove the air cleaner housing brackets.
6. Disconnect the exhaust gas recirculation (EGR) valve connector.
7. Remove the EGR passage.
8. Remove the EGR valve.
Installation
1. Install the EGR valve (A) with a new gasket (B).
2. Install the EGR passage (A) with a new gasket (B).
3. Connect the EGR valve connector.
4. Install the air cleaner housing brackets.
5. Install the upper radiator hose (A), heater hose (B), and water bypass hose (C).
6. Install the harness holder bracket (A), then install the harness holder (B).
7. Install the air cleaner housing.
8. Refill the radiator with engine coolant, and bleed the air from the cooling system with the heater valve open (see step 6).
READ NEXT:
Fan, Fan Motor, Shroud Removal and Installation
Removal
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
2. Remove the bulkhead cover.
3. Disconnect the fan motor connectors (A) and hood
switch conn
Radiator Replacement
For Japan-produced Model
1. Drain the engine coolant.
2. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
3. Remove the bulkhead cover.
4. Remove the co
Fan Controls
Component Location Index
RADIATOR FAN RELAY
A/C CONDENSER FAN RELAY
FAN CONTROL RELAY
A/C CONDENSER FAN ASSEMBLY
RADIATOR FAN ASSEMBLY
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
E
SEE MORE:
Vents, Heating, and A/C
Vents, Heating, and A/C
Fan Control Dial
Turn this dial to increase or decrease
the fan speed and airflow.
Temperature Control Dial
Turning this dial clockwise increases
the temperature of the airflow.
Air Conditioning (A/C) Button
This button turns the air
conditioning on and off. T
Engine Compression Inspection
NOTE: After this inspection, you must reset the
powertrain control module (PCM), otherwise the PCM
will continue to stop the injectors from functioning.
Select PCM reset using the Honda Diagnostic System
(HDS).
1. Warm up the engine to normal operating
temperature (cooling fan comes on).
2. Turn t
