Honda CR-V: Avoiding Obstacles

Debris in the road can damage your suspension or other components.

Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep hole can cause your vehicle to tip or roll over.

READ NEXT:

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

 If You Get Stuck

Avoid driving on soft sand, deep mud, or other surfaces where you could get stuck. If you do happen to get stuck because of inclement weather or other conditions, choose a safe and appropria

SEE MORE:

 DTC 82-14: No Signal From the Front Passenger's Weight Sensor (front inner side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 82-14 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From the SRS INSPE

 Memorizing the Tire Pressure Sensor ID

Special Tools Required TPMS sensor initializer tool AKS0620006 Available through the American Honda Tool and Equipment program, 888-424-6857. All four tire pressure sensor IDs must be memorized to the TPMS control unit whenever you do any of these actions: Replace the TPMS control unit. Replace

© 2016-2026 Copyright www.hcrv.net