Honda CR-V: EGR Passage Removal and Installation
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B).
4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C).
5. Remove the air cleaner housing brackets.
6. Disconnect the exhaust gas recirculation (EGR) valve connector.
7. Remove the EGR passage.
8. Remove the EGR valve.
Installation
1. Install the EGR valve (A) with a new gasket (B).
2. Install the EGR passage (A) with a new gasket (B).
3. Connect the EGR valve connector.
4. Install the air cleaner housing brackets.
5. Install the upper radiator hose (A), heater hose (B), and water bypass hose (C).
6. Install the harness holder bracket (A), then install the harness holder (B).
7. Install the air cleaner housing.
8. Refill the radiator with engine coolant, and bleed the air from the cooling system with the heater valve open (see step 6).
READ NEXT:
Fan, Fan Motor, Shroud Removal and Installation
Removal
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
2. Remove the bulkhead cover.
3. Disconnect the fan motor connectors (A) and hood
switch conn
Radiator Replacement
For Japan-produced Model
1. Drain the engine coolant.
2. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
3. Remove the bulkhead cover.
4. Remove the co
Fan Controls
Component Location Index
RADIATOR FAN RELAY
A/C CONDENSER FAN RELAY
FAN CONTROL RELAY
A/C CONDENSER FAN ASSEMBLY
RADIATOR FAN ASSEMBLY
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
E
SEE MORE:
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor connections or loose pins at all
connectors related to the circuit that you are
troubleshooting. If
Under-hood/dash Fuse/Relay Box
Under-hood Fuse/Relay Box
Removal and Installation
Removal
1. Make sure you have the anti-theft codes for the
audio and navigation system. If equipped with XM
radio, write down the XM radio presets.
2. Make sure the ignition switch is OFF.
3. Disconnect the negative battery cable, then
disconnect
