Honda CR-V: Glass
Honda CR-V (2006–2011) Service Manual / Body / Glass
Component Location Index
- WINDSHIELD MOLDING
- MOLDING UPPER SEAL
- UPPER RUBBER DAM
- CLIP, 2
- WINDSHIELD SIDE TRIM
- SIDE RUBBER DAM
- WINDSHIELD
- RETAINER,8
- QUARTER GLASS MOLDING
- CLIP, 1
- CLIP, 2
- QUARTER GLASS
- ULEV STICKER
- FRONT SEAL
- UPPER RUBBER DAM
- UPPER FASTENER 2
- FASTENER 2
- LOWER FASTENER 2
- LOWER RUBBER DAM
- 4 WD STICKER
- REAR WINDOW
READ NEXT:
Windshield Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging the seat.
When replacing a broken windshield, a commerci
Rear Window Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
Do not damage the rear window defogger gri
Quarter Glass Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
The quarter glass molding will need replac
SEE MORE:
System Description
Security Alarm System
NOTE: This applies to EX and EX-L models.
The security alarm system is armed automatically after the doors, hood, and
tailgate are closed and locked. For the
system to arm, the ignition switch must be off, the key must be removed from the
ignition switch, and the MICU must
re
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remove the boot bands. Be careful not to damage the boot.
3. Make marks (A) on each roller (B) and inboa
© 2016-2025 Copyright www.hcrv.net
