Honda CR-V: To Play the FM/AM Radio

The ignition switch must be in the ACCESSORY (I) or ON (II) position.

Turn the system on by pushing the FM or AM button. Adjust the volume by turning the VOL/SELECT knob.

The band and frequency that the radio was last tuned to are displayed.

To change bands, press the AM or FM button. On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction in AM is not available.

READ NEXT:

 To Select a Station

You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE - Use the SEEK button to tune to a desired frequency.

 Adjusting the Sound

Press the sound ( ) button to select an appropriate setting: bass, treble, fader, balance, subwoofer (if equipped), and SVC (speed-sensitive volume compensation). Turn the VOL/SELECT knob

 Audio System Lighting

You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the system is tu

SEE MORE:

 DTC P0712: Short in ATF Temperature Sensor Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Check the ATF temperature sensor voltage

 Valve Clearance Adjustment

Special Tools Required Adjuster 07MAA-PR70110 Locknut wrench 07MAA-PR70120 NOTE: Adjust the valves only when the cylinder head temperature is less than 100 ºF (38 ºC). 1. Remove the cylinder head cover. 2. Set the No.1 piston at top dead center (TDC). The punch mark (A) on the variable valve

© 2016-2025 Copyright www.hcrv.net