Honda CR-V manuals

Honda CR-V: Compass Operation

Honda CR-V (2006–2011) Owner's Manual / Features / Compass / Compass Operation

Next to the outside temperature

Next to the outside temperature indicator of the information display, a compass indicates which direction your vehicle is pointed. It indicates eight directions.

N: North
S: South
E: East
W: West
NE: Northeast
NW: Northwest
SE: Southeast
SW: Southwest

For example, when your vehicle is traveling in the north-east direction, the compass shows ‘‘NE’’ in the display.

Compass operation can be affected by driving near power lines or stations, across bridges, through tunnels, over railroad crossings, past large vehicles, or driving near large objects that can cause a magnetic disturbance. It can also be affected by accessories such as antennas and roof racks that are mounted by magnets.

READ NEXT:

 Compass Calibration

If you see ‘‘- -’’ in the direction display when you turn the ignition switch to the ON (II) position, the compass is self-calibrating. The compass may need to be manually calibrate

 Compass Zone Selection

In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:

 Security System

If equipped The security system helps to protect your vehicle and valuables from theft. The horn sounds and a combination of headlights, parking lights, side marker lights and taillights flash

SEE MORE:

 Side Engine Mount Bracket Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the upper torque rod. 3. Remove the ground cable (A), then remove the side engine mount bracket (B). 4. Install the side engine mount bracket, then loosely tighten the new bolt and nut (C), and loosely tighten the bolt

 Evaporator Core Replacement

1. Recover the refrigerant with a recovery/recycling/ charging station. 2. Remove the bolt from the A/C line clamp, and remove the receiver line (A) from the clips (B). 3. Remove the nut, then disconnect the A/C lines (A) from the evaporator core. 4. Remove the stud bolt. 5. Remove the blower un

© 2016-2025 Copyright www.hcrv.net