Honda CR-V manuals

Honda CR-V: Replacing a High-mount Brake Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a High-mount Brake Light Bulb

1. Open the tailgate.

1. Open the tailgate.

Unlatch the top of the cover by pulling back on it with your hands.

2. Place a cloth on the side edge of

2. Place a cloth on the side edge of the cover to prevent scratches.

Remove the cover by carefully prying on the edge with a small flat-tip screwdriver and pulling the cover off.

3. Remove the socket from the light assembly by turning it one-quarter turn counterclockwise.

4. Pull the bulb straight out of its

4. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

5. Press the brake pedal to make sure the new bulb is working.

6. Put the socket back into the light assembly, and turn it clockwise to lock it in place.

7. Put the cover back on the light assembly. Push it in until it locks in place.

READ NEXT:

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropy

 Floor Mats

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the f

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

SEE MORE:

 APP Sensor Signal Inspection

NOTE: This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot

 Rear Brake

Rear Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07AAE-SEPA101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to -your health. Avoid breathing dust particles. Never use an air hose or brush to

© 2016-2025 Copyright www.hcrv.net