Honda CR-V: MICU Input Test
NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.
1. Turn the ignition switch OFF.
2. Disconnect the under-dash fuse/relay box connectors E, F, G, K, R, and T.
NOTE: All connector views are wire side of female terminals.
UNDER-DASH FUSE/RELAY BOX CONNECTOR E (42P)

UNDER-DASH FUSE/RELAY BOX CONNECTOR F (34P)

UNDER-DASH FUSE/RELAY BOX CONNECTOR G (21P)

UNDER-DASH FUSE/RELAY BOX CONNECTOR K (8P)

UNDER-DASH FUSE/RELAY BOX CONNECTOR R (20P)

UNDER-DASH FUSE/RELAY BOX CONNECTOR T (34P)

3. Inspect the connector and socket terminals to be sure they are all making
good contact.
- If the terminals are bent, loose or corroded, repair them as necessary
and recheck the system.
- If the terminals look OK, go to step 4.
4. With the connector still disconnected, make these input tests at the
appropriate connector.
- If any test indicates a problem, find and correct the cause, then
recheck the system.
- If all the input tests prove OK, go to step 5.

5. Reconnect the connectors to the under-dash fuse/relay box, and make these
input tests at the connectors.
- If any test indicates a problem, find and correct the cause, then
recheck the system.
- If all the input tests prove OK, the MICU must be faulty; replace the
under-dash fuse/relay box.

READ NEXT:
Component Location Index
NAVIGATION UNIT or
AUDIO UNIT
IMMOBILIZER-KEYLESS
CONTROL UNIT
(Built-in receiver)
MICU (Built into the under-dash fuse/relay box)
HEADLIGHTS
HORN
HOOD SWITCH
SECUR
Security Alarm System
NOTE: This applies to EX and EX-L models.
The security alarm system is armed automatically after the doors, hood, and
tailgate are closed and locked. For the
system to arm, the
DTC B1026: Front Passenger's Door Lock
Switch Signal Error (LOCK/UNLOCK)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System Diagnosis Test Mode A.
1. Cl
SEE MORE:
Component Location Index
AIR CLEANER
RESONATOR
THROTTLE BODY
INTAKE AIR BYPASS CONTROL
THERMAL VALVE
Throttle Body Test
Carbon Accumulation Check
NOTE: If the malfunction indicator lamp (MIL) has been
reported on, check for diagnostic trouble codes (DTCs).
1. Connect the H
Avoid driving on soft sand, deep mud,
or other surfaces where you could
get stuck. If you do happen to get
stuck because of inclement weather
or other conditions, choose a safe
and appropriate course of action.
You should never use a jack to try
getting unstuck. A jack only works
on f
© 2016-2025 Copyright www.hcrv.net
