Honda CR-V: Installing a Child Seat with a Tether
A child seat with a tether can be installed in any seating position in the back seat.
Each rear outside seating position has an anchorage point on the seatback, and the center seating position has an anchorage point in the ceiling near the tailgate.
Since a tether can provide additional security to the lap/shoulder belt installation, we recommend using a tether whenever one is required or available.
Using an Outer Anchor
1. On vehicles with the dual deck cargo shelf, remove it.
2. After properly securing the child seat with the lap/shoulder belt, route the tether strap over the top of the seat-back and through the legs of the head restraint.
3. Attach the tether strap hook to the anchor, making sure the tether strap is not twisted.
4. Tighten the strap according to the seat maker’s instructions.
5. Reinstall the dual deck cargo shelf.
Using the Center Anchor
1. Remove the rear center head restraint, and store it in the cargo area.
2. After properly securing the child seat, open the anchor cover.
3. Route the tether strap over the seat-back, then attach the tether strap hook to the anchor, making sure the tether strap is not twisted.
4. Tighten the strap according to the seat maker’s instructions.
READ NEXT:
Protecting Larger Children
When a child reaches the
recommended weight or height limit
for a forward-facing child seat, the
child should sit in a back seat on a
booster seat and wear the lap/
shoulder belt.
The follo
Checking Seat Belt Fit
To determine if a lap/shoulder belt
properly fits a child, have the child
put on the seat belt, then ask
yourself:
1. Does the child sit all the way back
against the seat?
2. Do the chil
Using a Booster Seat
A child who has outgrown a forwardfacing
child seat should ride in a
back seat and use a booster seat
until the lap/shoulder belt fits them
properly without the booster.
Some states, Cana
SEE MORE:
Pump
Pump Replacement
1. Place a suitable container under the vehicle.
2. Drain the power steering fluid from the reservoir.
3. Remove the drive belt (A) from the pump pulley.
4. Cover the auto-tensioner, alternator, and A/C
compressor with several shop towels to protect
them from spilled power steeri
Multiplex Integrated Control System
Component Location Index
GAUGE CONTROL MODULE
Input Test
Replacement
IMMOBILIZER-KEYLESS CONTROL UNIT
(Built in receiver)
MICU (Built into the under-dash fuse/relay box)
Input Test
Replacement
General Troubleshooting Information
Troubleshooting CAN Circuit Related Problems
NOT
