Honda CR-V manuals

Honda CR-V: Steering Wheel Adjustment

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Steering Wheel Adjustment

Make any steering wheel adjustment before you start driving.

Adjusting the steering wheel

Adjusting the steering wheel position while driving may cause you to lose control of the vehicle and be seriously injured in a crash.

Adjust the steering wheel only when the vehicle is stopped.

1. Push the lever under the steering column all the way down.

2. Move the steering wheel up or down, and in or out, so it points toward your chest, not toward your face. Make sure you can see the instrument panel gauges and indicators.

3. Push the lever up to lock the

3. Push the lever up to lock the steering wheel in position.

4. Make sure you have securely locked the steering wheel in place by trying to move it up, down, in, and out.

READ NEXT:

 Keys and Locks

The master key fits all the locks on your vehicle. The valet key works only in the ignition and the driver’s door lock. You can keep the glove box locked when you leave your vehicle an

 Immobilizer System

The immobilizer system protects your vehicle from theft. If an improperly coded key (or other device) is used, the engine’s fuel system is disabled. When you turn the ignition switch to t

 Ignition Switch

The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, the shift lev

SEE MORE:

 Horns

Component Location Index HORN HORN SWITCH HORN RELAY CIRCUIT (Built into the MICU) CABLE REEL UNDER-DASH FUSE/RELAY BOX Circuit Diagram Horn Switch Test 1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 20P connector (A) from the cable reel (B). 3. Usin

 Valve, Spring, and Valve Seal Removal

Special Tools Required Valve spring compressor attachment 07757-PJ1010A Identify the valves and valve springs as they are removed so that each item can be reinstalled in its original position. 1. Remove the cylinder head. 2. Using an appropriate-sized socket (A) and plastic mallet (B), lightly tap

© 2016-2025 Copyright www.hcrv.net