Honda CR-V: Braking System Design

The hydraulic system that operates the brakes has two separate circuits.

Each circuit works diagonally across the vehicle (the left-front brake is connected with the right-rear brake, etc.). If one circuit should develop a problem, you will still have braking at two wheels.

READ NEXT:

 Brake PadWear Indicators

The front and rear disc brakes on all models have audible brake wear indicators. If the brake pads need replacing, you will hear a distinctive, metallic screeching sound when you apply the

 Anti-lock Brakes (ABS)

The anti-lock brake system (ABS) helps prevent the wheels from locking up, and helps you retain steering control by pumping the brakes rapidly, much faster than a person can do it. The elec

 Vehicle Stability Assist (VSA ), aka Electronic Stability Control (ESC), System

The vehicle stability assist (VSA) system helps to stabilize the vehicle during cornering if the vehicle turns more or less than desired. It also assists you in maintaining traction while ac

SEE MORE:

 Upper/Lower Front Grille Replacement

Upper Front Grille Replacement NOTE: Take care not to scratch the bumper and grille. 1. Remove the front bumper. 2. Remove the clips from the back of the front grille and release the hooks (A), then release the hooks (B) and remove the upper front grille (C) from the lower front grille (D). 3. Re

 Front Driveshaft Installation

1. Apply grease to the contact area (A) of the outboard joint and front wheel bearing. NOTE: Failure to apply grease may cause excessive noise and vibration. 2. Install a new set ring (A) onto the set ring groove (B) of the driveshaft (left driveshaft). 3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease

© 2016-2025 Copyright www.hcrv.net