Honda CR-V: Ventilation
The flow-through ventilation system draws in outside air, circulates it through the interior, then discharges it through vents near the tailgate.
1. Set the temperature to the lower
limit.
2. Make sure the A/C is off.
3. Select
and fresh air mode.
4. Set the fan to the desired speed.
READ NEXT:
Using the Heater
The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes before you
feel warm air coming from the
system.
1. Select
.
When you select
, the system
Using the A/C
Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge. If it moves near the red zone,
turn off the A/C until the gauge
reading returns to normal.
1.
Dehumidify the Interior
Air conditioning, as it cools, removes
moisture from the air.When used in
combination with the heater, it
makes the interior warm and dry and
can prevent the windows from
fogging up.
1. Tur
SEE MORE:
DTC 11, 13, 15, 17: Wheel Sensor (Open/Short
to Body Ground/Short to Power)
1. Turn the ignition switch ON (II).
2. Check for DTCs with the HDS.
Is DTC 87 indicated with DTC 11,13,15, and/or 17
at the same time?
YES-Go to step 9.
NO-Go to step 3.
3. Clear the DTC with the HDS.
4. Turn the ignition switch OFF, then turn it ON (II)
again.
5. Check for DTCs with the HDS.
Evaporator Core
Replacement
1. Recover the refrigerant with a recovery/recycling/ charging station.
2. Remove the bolt from the A/C line clamp, and
remove the receiver line (A) from the clips (B).
3. Remove the nut, then disconnect the A/C lines (A)
from the evaporator core.
4. Remove the stud bolt.
5. Remove the blower un
© 2016-2025 Copyright www.hcrv.net
