Honda CR-V manuals

Honda CR-V: Daytime Running Lights

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Daytime Running Lights

With the headlight switch in the off or the high beam position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II) position and release the parking brake. They remain on until you turn the ignition switch off, even if you set the parking brake.

The headlights revert to normal operation when you turn them on with the switch.

READ NEXT:

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

SEE MORE:

 Oil Pump Overhaul

Exploded View Oil Pump Removal 1. Turn the crankshaft pulley so its top dead center (TDC) mark (A) lines up with the pointer (B). 2. Remove the oil pan. 3. Remove and discard the oil pump chain tensioner. 4. To hold the rear balancer shaft, insert a 6 mm pin driver (A) into the maintenance hole

 Symptom Troubleshooting

Hard Steering 1. Check the power assist. Is the initial turning load more than 34 N (3.5 kgf, 7.7 Ibf) ? YES-Go to step 2. NO-Power assist is OK. 2. Connect the P/S joint adapter (pump), P/S joint adapter (hose), and P/S pressure gauge T/N 07406- 0010001 (see page 17-9), T/N 07406-001000A or T/N

© 2016-2025 Copyright www.hcrv.net