Honda CR-V: Cruise Control
Component Location Index
- CRUISE MAIN INDICATOR
- CRUISE CONTROL INDICATOR
- CRUISE CONTROL COMBINATION SWITCH
- BRAKE PEDAL POSITION SWITCH
-
POWERTRAIN CONTROL MODULE (PCM)
-
TRANSMISSION RANGE SWITCH
Symptom Troubleshooting Index
Circuit Diagram
Cruise Control Input Test
1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2).
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle and the powertrain control module (PCM). If it doesn't, troubleshoot the DLC circuit.
4. Go to PGM-FI, and check for DTCs.
5. Do the following tests while monitoring parameters in the PGM-FI DATA LIST with the HDS.
NOTE: Intermittent failures are often caused by loose circuit connections. While monitoring cruise control inputs, flex their circuits, and note if any of the test results change.
Cruise Control Combination Switch Test/Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Remove the steering wheel.
2. Remove the screws (A). Disconnect the 12P connector (B), then remove the cruise control combination switch.
3. Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, but switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or more positions, replace the switch.
4. Check for continuity between the terminals in according to the table.
- If there is continuity, and it matches the table, check and repair the wire harness on the switch circuit.
- If there is no continuity in one or more positions, replace the switch.
Engine Electrical
Special Tools
-
Attachment, 42 x 47 mm
-
Driver
READ NEXT:
Engine Removal
Universal eyelet 07AAK-SNAA120
Engine hanger adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
CR-V engine hanger adapter VSB02C000032 *
Engine support hanger, A and Reds AAR-T-12566
SEE MORE:
Radiator and A/C Condenser Fan Low Speed Circuit Troubleshooting
NOTE:
Do not use this troubleshooting procedure if the A/C
compressor is inoperative. Refer to the symptom
troubleshooting index.
Before doing symptom troubleshooting, check for
powertrain DTCs.
1. Check the No.7 (20 A) fuse in the under-hood
fuse/relay box, and the No. 36 (10 A) fuse in the
Load Limits
The maximum load for your vehicle
is 850 lbs (385 kg) for U.S. vehicles,
and 395 kg for Canadian vehicles.
This figure includes the total weight
of all occupants, cargo, and
accessories, and the tongue load if
you are towing a trailer.
See Tire And Loading Information
label attached to
