Honda CR-V: Rear Window Wiper and Washer

1. OFF
When you turn the wiper switch to
the ‘‘OFF’’ position, the wiper will
return to its parked position.
2. Rotate the switch clockwise to
turn the rear window wiper ON.
The wiper operates every 7
seconds after completing two
sweeps.
3. Hold past ON to activate the rear
window wiper a few times and to
spray the rear window washer.
4. Rotate the switch counterclockwise also to spray the
window washer and turn the wiper
on.
When you shift the transmission to
the reverse position with the front
windshield wiper activated, the rear
wiper operates automatically even if
the rear wiper switch is off.
The rear window washer uses the
same fluid reservoir as the windshield
washer.
READ NEXT:
1. Turn Signal
2. OFF
3. Parking and interior lights
4. AUTO
5. Headlights on
6. High Beams
7. Flash high beams
*: If equipped
Turn Signal - Push down on the
lever to signal a left turn
With the headlight switch in the off
or
position,
the high beam
headlights and the high beam
indicator come on with reduced
brightness when you turn the
ignition switch to the ON (II)
You can change the instrument panel
brightness only when the light
switch is on.
Turn the knob on the lower part of
the instrument panel to adjust the
brightness.
You will hear a beep wh
SEE MORE:
General Operation
Refer to the navigation system manual, for the
navigation system operating procedures.
Anti-theft Feature
The navigation system has a coded theft protection
circuit. Make sure you have the customer's anti-theft
security code before;
Disconnecting the battery
Disconnecting the na
If you suspect a problem with the fuel pump, check that
the fuel pump actually runs; when it is on, you will hear
some noise if you listen to the fuel fill port with the fuel
f ill cap removed. The fuel pump should run for
2 seconds when the ignition switch is first turned on. If
the fuel pump does
© 2016-2025 Copyright www.hcrv.net
