Honda CR-V: Rearview Camera and Monitor

Honda CR-V (2006–2011) Owner's Manual / Features / Rearview Camera and Monitor

On EX-L model with navigation system

Whenever you shift to reverse (R)

Whenever you shift to reverse (R) with the ignition switch in the ON (II) position, the rearview is shown on the navigation system screen.

For the best picture, always keep the rearview camera clean, and do not cover the camera lens. To avoid scratching the lens when you clean it, use a moist, soft cloth.

When in reverse, the touch screen and navigation system ‘‘hard’’ buttons are locked out, except the ‘‘ZOOM’’ button. Touching the ‘‘ or ‘‘  ’’ button allows you to ’’ or ‘‘ adjust ’’ button allows you to adjust the brightness of the rearview camera image.

The camera brightness cannot be

The camera brightness cannot be adjusted by voice control.

Since the rearview camera display area is limited, you should always back up slowly and carefully, and look behind you for obstacles.

READ NEXT:

 Cruise Control

Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without keeping your foot on the accelerator pedal. It should be used for cruising on straight, open highways. It is

 Using the Cruise Control

1. Push the CRUISE button on the steering wheel. The CRUISE MAIN indicator on the instrument panel comes on. The cruise control systemcan be left on, even when it is not in use. 2. Acceler

 Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. To increase the speed in ver

SEE MORE:

 Resetting the Engine Oil Life Display

Your dealer will reset the display after completing the required maintenance service. You will see ‘‘OIL LIFE 100%’’ on the information display the next time you turn the ignition switch to the ON (II) position. If maintenance service is done by someone other than your dealer,

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropyl alcohol. If your seat belts get dirty, use a soft brush with a mixture of mild soap and warm

© 2016-2025 Copyright www.hcrv.net