Honda CR-V: Driver's Airbag Replacement

Removal

1. Disconnect the negative cable from the battery and wait at least 3 minutes before beginning work.

2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) and horn switch 1P connector (C) from the cable reel.

Honda CR-V. SRS (Supplemental Restraint System)

3. Using a TORX T30 bit, remove the two TORX bolts (A).

Honda CR-V. SRS (Supplemental Restraint System)

4. Remove the driver's airbag (B).

Installation

1. Connect the horn switch connector (1P) (A) to the driver's airbag (B).

Honda CR-V. SRS (Supplemental Restraint System)

2. Place the driver's airbag in the steering wheel, and secure it with new TORX bolts (C).

3. Connect the cable reel 4P connector (A) to the driver's airbag 4P connector, then install the access panel (B) on the steering wheel.

Honda CR-V. SRS (Supplemental Restraint System)

4. Connect the negative cable from the battery.

5. After installing the airbag, confirm proper system operation:

READ NEXT:

 Front Passenger's Airbag Replacement

Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Remove the passenger's vent panel. 3. Remove the dashboard center upper panel. 4. Re

 Side Airbag Replacement

NOTE: Review the seat replacement procedure before doing repairs or service. Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Disconnec

 Airbag and Tensioner Disposal

Special Tools Required Deployment tool 07HAZ-SG00500 Before scrapping any airbags, side airbags, side curtain airbags, seat belt tensioners; or lap belt tensioner (including those in a whole vehicle t

SEE MORE:

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals or "T" for non-ground terminals. * 1. With seat heater * 2: Without seat heater Connector to Harne

 DTC P1009: VTC Advance Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0341 is stored at the same time as DTC P1009, troubleshoot DTC P1009 first, then recheck for DTC P0341. 1. Turn the ignition switch ON (II). 2. Clear

© 2016-2025 Copyright www.hcrv.net