Honda CR-V: To Stop Playing a Disc

To play the radio when a disc is playing, press the AM/FM button or touch the FM1, FM2, AM, XM1, or XM2 icon. If a PC card is in the audio unit, touch the CARD icon to play the PC card. If a CD or CDs are loaded in the CD changer, touch the CDC icon to play the CD changer.

Press the CD button again or touch the CD icon to switch back to the disc player.

If you turn the system off while a disc is playing, either with the power/volume knob or by turning off the ignition switch, the disc will stay in the drive.When you turn the system back on, the disc will begin playing where it left off.

READ NEXT:

 Removing a Disc

To remove a disc from the audio unit, fold back the screen by pressing the OPEN button. Press the disc eject button ( ) to remove the disc. If you eject the disc, but do not remove it from

 Disc Player Error Messages (EX-L model with navigation system)

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer. The cha

 CD Changer (EX-L model with navigation system)

CD Changer (EX-L model with navigation system)

SEE MORE:

 Valve, Spring, and Valve Seal Installation

Special Tools Required Stem seal driver 07PAD-001 0000 Valve spring compressor attachment 07757-PJ1010A 1. Coat the valve stems with engine oil. Install the valves in the valve guides. 2. Check that the valves move up and down smoothly. 3. Install the spring seats on the cylinder head. 4. Ins

 Heater Unit/Core Replacement

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service. 1. Make sure you have anti-theft codes for the audio system and the navigation system (if equipped). 2. Make sure the ignition is OFF, then disconnect the

© 2016-2025 Copyright www.hcrv.net