Honda CR-V: Windshield Washers

Check the fluid level in the windshield washer reservoir at least monthly during normal use.

Check the fluid level by removing

Check the fluid level by removing the cap and looking at the level gauge.

On Canadian models: The low washer level indicator comes on when the level is low.

Fill the reservoir with a good-quality windshield washer fluid. This increases the cleaning capability and prevents freezing in cold weather.

When you refill the reservoir, clean the edges of the windshield wiper blades with windshield washer fluid on a clean cloth. This will help to condition the blade edges.

Do not use engine antif reeze or a

Do not use engine antif reeze or a vinegar/water solution in the windshield washer reservoir. Antif reeze can damage your vehicle’s paint, while a vinegar/water solution can damage the windshield washer pump. Use only commercially-available windshield washer f luid.

READ NEXT:

 Automatic Transmission Fluid

Check the fluid level with the engine at normal operating temperature. 1. Park the vehicle on level ground. Start the engine, let it run until the radiator fan comes on, then shut off the en

 Rear Differential Fluid

4WD model only The rear differential should be drained and refilled with new fluid according to the maintenance messages shown on the information display. Have your dealer replace the rear

 Brake Fluid

Check the fluid level in the brake fluid reservoir monthly. Replace the brake fluid according to the maintenance messages shown on the information display. Always use Honda Heavy Duty Brake

SEE MORE:

 Tire Pressure Sensor Replacement

Removal 1. Raise the vehicle, and support it with safety stands in the proper locations. 2. Remove the wheel with the faulty sensor. 3. Remove the tire valve cap and the valve core, and let the tire deflate. 4. Remove any balance weights, and then break the bead loose from the wheel with a comme

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot. N

© 2016-2025 Copyright www.hcrv.net