Honda CR-V manuals

Honda CR-V: Daytime Running Lights

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Daytime Running Lights

With the headlight switch in the off or the high beam position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II) position and release the parking brake. They remain on until you turn the ignition switch off, even if you set the parking brake.

The headlights revert to normal operation when you turn them on with the switch.

READ NEXT:

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

SEE MORE:

 DTC P1116: ECT Sensor 1 Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0111 is stored at the same time as DTC P1116, troubleshoot DTC P0111 first, then recheck for DTC P1116. 1. Check for poor connections or loose terminal

 Steering

Special Tools Piston Seal Ring Sizing Tool Bushing Base Piston Seal Ring Guide Cylinder End Seal Slide Locknut Wrench, 40 mm Ball Joint Remover, 28 mm Valve Seal Ring Sizing Tool Sleeve Seal Ring Guide Pulley Holder Sleeve Seal Ring Sizing Tool, 36 mm P/S Joint Adapter (pump) P/S Join

© 2016-2025 Copyright www.hcrv.net