Honda CR-V: Door Lower Trim Replacement

NOTE:

1. Remove these items:

2. From the front or the rear door, remove the screw.

Honda CR-V. Exterior Trim

3. Using a utility knife, carefully cut the double-sided adhesive tape (A) along the edge of the door lower trim (B).

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

4. With the help of an assistant, slide the door lower trim (A) rearward, and remove it. The clips (B, C) stay in the body. Turn the clips (B) 45 º counterclockwise, and remove them.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

5. Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.

6. Install the clips on the trim.

7. Scrape off the remaining double-sided adhesive tape from the trim and door, then clean the trim and door surfaces with a sponge dampened in isopropyl alcohol.

8. Apply primer to the area where the panel will be applied.

9. Attach the double-sided adhesive tape (A) to the trim (B), and fold the edge of each adhesive backing from the double-sided adhesive tape.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

10. Hold the trim (A) up, and fit all the clips (B, C) into the holes in the door, then push on the trim until the clips snap into place.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

11. Carefully pull the adhesive backing (D) away, and push the trim into place securely.

12. Set the screw into the back of clip, then reinstall the door speaker and the door panel.

READ NEXT:

 Side Windshield Trim Replacement

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not t

 Fenderwell

Front Inner Fender Replacement NOTE: Take care not to scratch the body. 1. Remove the front wheel arch protector, as needed. 2. Remove the front inner fender (A). Remove the screws (B, C), and remo

 Openers

Component Location Index HOOD OPENER CABLE Replacement FUEL FILL DOOR OPENER Replacement TAILGATE LATCH Replacement FUEL FILL DOOR LATCH Replacement FUEL FILL DOOR OPENE

SEE MORE:

 Installing a Child Seat with LATCH

Your vehicle is equipped with LATCH (Lower Anchors and Tethers for CHildren) at the rear seats to secure a child seat in any seating position: one in each outer seating position, or one in the center. The five lower anchors are located between the seat-back and seat bottom, and are to

 Folding the Rear Seats Down

Each rear seat-back can be folded down separately to give more cargo room. With either of the outer seatbacks folded-down, you can still carry a passenger in the rear seat. With the center seat-back foldeddown, either outer seating position can be used. You can also fold up the left or

© 2016-2025 Copyright www.hcrv.net