Honda CR-V: Replacing a Front Turn Signal Light Bulb

1. Open the hood.
To change the turn signal bulb on
the driver’s side, remove the
engine coolant reserve tank by
pulling it out of its holder.

2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
4. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
5. Turn on the lights to make sure
the new bulb is working.
6. (Driver’s side)
Reinstall the coolant reserve tank.
READ NEXT:
1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.
2. Remove the socket from the
headlight assembly
1. Open the tailgate. Place a cloth on
the edge of the cover to prevent
scratches. Remove the covers by
carefully prying on the edge with a
small flat-tip screwdriver.
2. Use a Phillips-h
1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.
2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
SEE MORE:
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine, and wait 1 minute.
4. Check for Temporary DTCs or DTCs with the HDS.
Is DT
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the SRS component locations and the
precautions and procedures before
doing repairs or service.
NOTE:
Use the a
© 2016-2025 Copyright www.hcrv.net
