Honda CR-V: Using the Cruise Control

1. Push the CRUISE button on the

1. Push the CRUISE button on the steering wheel. The CRUISE MAIN indicator on the instrument panel comes on.

The cruise control systemcan be left on, even when it is not in use.

2. Accelerate to the desired cruising speed above 25 mph (40 km/h).

3. Press and release the SET/ DECEL button on the steering wheel. The CRUISE CONTROL indicator on the instrument panel comes on to show the system is now activated.

Cruise control may not hold the set speed when you are going up and down hills. If your vehicle speed increases going down a hill, use the brakes to slow down. This will cancel the cruise control. To resume the set speed, press the RES/ACCEL button.

The CRUISE CONTROL indicator on the instrument panel will come back on.

READ NEXT:

 Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. To increase the speed in ver

 Canceling Cruise Control

You can cancel cruise control in any of these ways: Tap the brake pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel.

 Resuming the Set Speed

When you push the CANCEL button, or tap the brake pedal, the system remembers the previously set speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and relea

SEE MORE:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

 Cam Chain Removal

NOTE: Keep the cam chain away from magnetic fields. 1. Remove the front wheels. 2. Remove the splash shield (see step 21). 3. Remove the drive belt. 4. Remove the cylinder head cover. 5. Set the No.1 piston at top dead center (TDG). The punch mark (A) on the variable valve timing control (VTG) a

© 2016-2025 Copyright www.hcrv.net