Honda CR-V: MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box.

2. Disconnect under-dash fuse/relay box connectors E, F, S, and T.

NOTE: All connector views are wire side of female terminals.

Honda CR-V. Wipers/Washers

3. Inspect the connector and socket terminals to be sure they are all making good contact.

4. With the connectors still disconnected, make these input tests at the appropriate connector.

Honda CR-V. Wipers/Washers

5. Reconnect the connectors to the under-dash fuse/relay box, and make these input tests at the connectors.

Honda CR-V. Wipers/Washers

READ NEXT:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

 Gauges

Component Location Index GAUGE CONTROL MODULE Self-diagnostic Function Input Test Rewriting the ODO Data and Transferring Smart Maintenance on a New Gauge Control Module Replacement Out

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition s

SEE MORE:

 Tailgate

The tailgate will lock when you lock the driver’s door with the key, the remote transmitter, the master door lock switch, or the lock tab on the driver’s door. To unlock the tailgate, turn the key clockwise twice, push the rear of the master door lock switch, or push the UNLOCK bu

 General Information

Your vehicle has been designed primarily for use on pavement. But its higher ground clearance allows you to occasionally travel on unpaved roads, such as campgrounds, picnic sites, and similar locations. It is not designed for trail-blazing, mountain climbing, or other challenging offr

© 2016-2025 Copyright www.hcrv.net