Honda CR-V: Important Safety Precautions

To avoid loss of control or rollover, be sure to follow all precautions and recommendations.

Be sure to store cargo properly and do not exceed your cargo load limits.

Wherever you drive, make sure you and your passengers always wear seat belts.

Keep your speed low, and never go faster than the conditions allow.

It’s up to you to continually assess the situation and drive within the limits.

READ NEXT:

 Check Out Your Vehicle

Before you leave the pavement, be sure to do all scheduled maintenance and service, and inspect your vehicle for any problems. Pay special attention to the condition of the tires, and check

 Remember

The route presents limits (too steep or bumpy roads). You have limits (driving skill and comfort). And your vehicle has limits (traction, stability, and power). Driving off-highway can be h

 Accelerating and Braking

For better traction on all surfaces, accelerate slowly and gradually build up speed. If you try to start too fast on wet soil, mud, snow, or ice, you might not have enough traction to get un

SEE MORE:

 DTC Troubleshooting

DTC B1000: Communication Bus Line Error (Bus-off) 1. Clear the DTCs with the HDS. 2. Turn the ignition switch OFF, and then back ON (II). 3. Wait for 6 seconds or more. 4. Check for DTCs with the HDS. Is DTCs B1000 and/or B1008 and B1011 indicated? YES-Go to step 5. NO-Intermittent failure, the

 Valve Body

Valve Body and ATF Strainer Removal NOTE: The illustration shows the 4WD transmission; the 2WD is similar. 1. Remove the ATF feed pipes (A) and ATF joint pipes (B). 2. Remove the ATF strainer (C) (two bolts), 3. Remove the regulator valve body (D) (eight bolts), 4. Remove the stator shaft (E) and

© 2016-2025 Copyright www.hcrv.net