Honda CR-V: EGR Passage Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System / EGR Passage Removal and Installation

Removal

1. Drain the engine coolant.

2. Remove the air cleaner housing.

3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B).

Honda CR-V. Cooling System

4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C).

Honda CR-V. Cooling System

5. Remove the air cleaner housing brackets.

Honda CR-V. Cooling System

6. Disconnect the exhaust gas recirculation (EGR) valve connector.

7. Remove the EGR passage.

Honda CR-V. Cooling System

8. Remove the EGR valve.

Honda CR-V. Cooling System

Installation

1. Install the EGR valve (A) with a new gasket (B).

Honda CR-V. Cooling System

2. Install the EGR passage (A) with a new gasket (B).

Honda CR-V. Cooling System

3. Connect the EGR valve connector.

4. Install the air cleaner housing brackets.

Honda CR-V. Cooling System

5. Install the upper radiator hose (A), heater hose (B), and water bypass hose (C).

Honda CR-V. Cooling System

6. Install the harness holder bracket (A), then install the harness holder (B).

Honda CR-V. Cooling System

7. Install the air cleaner housing.

8. Refill the radiator with engine coolant, and bleed the air from the cooling system with the heater valve open (see step 6).

READ NEXT:

 Fan, Fan Motor, Shroud Removal and Installation

Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disconnect the fan motor connectors (A) and hood switch conn

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the co

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 E

SEE MORE:

 DTC P0128: Cooling System Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Turn the blower switch OFF. 4. Check the FAN CTRL in the DATA LIST with the HDS. Is it OFF?

 Adjust the Seat-Backs

Adjust the driver’s seat-back to a comfortable, upright position, leaving ample space between your chest and the airbag cover in the center of the steering wheel. Passengers with adjustable seatbacks should also adjust their seatback to a comfortable, upright position. Recl

© 2016-2025 Copyright www.hcrv.net