Honda CR-V: Differential Mount Replacement
Exploded View
Differential Installation
1. Install rear differential mount assembly A to the rear differential assembly (B).
2. Jack up the rear differential.
3. Install the new set rings (A) onto the driveshafts, then insert the drives hafts into the rear differential.
4. Lift the rear differential up into position, then push on both driveshafts to lock the set rings into place.
Connect the breather tube (B).
5. Align the tab (A) of the rubber mount (B) with the hole (C) of the plates (D), then install the plates and torque the rear differential mount assembly mounting bolts (E).
NOTE: The rubber heat insulator (F) is installed only in the right side.
6. Install the breather tubes (G) to the clips (H).
7. Install the right and left rear differential mount brackets B (A), then torque the bolts (B).
8. Install the breather tube (C) to the clip (D).
9. Install the No.2 propeller shaft (A) onto the rear differential (B) by aligning the reference marks (C) made during removal. Make sure you use new mounting bolts (D).
10. Fill the rear differential with the differential fluid to the proper level.
READ NEXT:
Driveline/Axle
Special Tools
Oil Seal Driver
Attachment, 52 x 55 mm
Half Shaft Base
Threaded Adapter, 24 x 1.5 mm
Threaded Adapter, 26 x 1.5 mm
Attachment, 35 mm I.D.
Driver
Inner Handle, 30 mm
Oil Seal
Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot
(B) on the driveshaft (C) for cracks, damage, leaking
grease, and loose boot bands (D). If any damage is
found, replace the boot and boot bands.
2.
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remov
SEE MORE:
Replacing a Parking Light/Front Side Marker Light Bulb
1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. P
Using a Booster Seat
A child who has outgrown a forwardfacing
child seat should ride in a
back seat and use a booster seat
until the lap/shoulder belt fits them
properly without the booster.
Some states, Canadian provinces and
territories also require children to
use a booster seat until they reach a
