Honda CR-V: Fan, Fan Motor, Shroud Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System / Fan, Fan Motor, Shroud Removal and Installation

Removal

1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position.

Honda CR-V. Cooling System

2. Remove the bulkhead cover.

3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C).

Honda CR-V. Cooling System

4. Remove the radiator upper brackets (A), then remove the front bulkhead (B).

Honda CR-V. Cooling System

5. Remove the condenser fan shroud assembly (A), then remove the radiator fan shroud assembly (B) from condenser fan shroud side.

Honda CR-V. Cooling System

6. Disassemble the fan shrouds.

Honda CR-V. Cooling System

Installation

1. Assemble the fan shrouds.

Honda CR-V. Cooling System

2. Install the radiator fan shroud assembly (A), then install the condenser fan shroud assembly (B).

Honda CR-V. Cooling System

3. Install the front bulkhead (A), then install the radiator upper brackets (B).

Honda CR-V. Cooling System

4. Apply body paint to the bulkhead mounting bolts.

5. Connect the fan motor connectors (A) and hood switch connector (B), then install the harness clips (C).

Honda CR-V. Cooling System

6. Remove the bulkhead cover.

READ NEXT:

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the co

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 E

 Fuel and Emissions

SEE MORE:

 Temperature

The temperature grades are A (the highest), B, and C, representing the tire’s resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specified indoor laboratory test wheel. Sustained high temperature can cause the material

 CKP Pulse Plate Replacement

1. Remove the front wheels. 2. Remove the splash shield (see step 21). 3. Remove the drive belt. 4. Remove the cylinder head cover. 5. Set the No.1 piston at top dead center (TDC). The punch mark on the variable valve timing control (VTC) actuator and the punch mark on the exhaust camshaft sproc

© 2016-2026 Copyright www.hcrv.net