Honda CR-V: Door Lower Trim Replacement
NOTE:
- Take care not to scratch the door.
- Put on gloves to protect your hands.
1. Remove these items:
- Door panel, front , rear.
- Door speaker, front, rear.
2. From the front or the rear door, remove the screw.

3. Using a utility knife, carefully cut the double-sided
adhesive tape (A) along the edge of the door lower
trim (B).
Front door

Rear door

4. With the help of an assistant, slide the door lower
trim (A) rearward, and remove it. The clips (B, C)
stay in the body. Turn the clips (B) 45 º
counterclockwise, and remove them.
Front door

Rear door

5. Check if the clips are damaged or stress-whitened,
and if necessary, replace them with new ones.
6. Install the clips on the trim.
7. Scrape off the remaining double-sided adhesive
tape from the trim and door, then clean the trim
and door surfaces with a sponge dampened in
isopropyl alcohol.
8. Apply primer to the area where the panel will be
applied.
9. Attach the double-sided adhesive tape (A) to the
trim (B), and fold the edge of each adhesive
backing from the double-sided adhesive tape.
Front door

Rear door

10. Hold the trim (A) up, and fit all the clips (B, C) into
the holes in the door, then push on the trim until
the clips snap into place.
Front door

Rear door

11. Carefully pull the adhesive backing (D) away, and
push the trim into place securely.
12. Set the screw into the back of clip, then reinstall the
door speaker and the door panel.
READ NEXT:
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not t
Front Inner Fender Replacement
NOTE: Take care not to scratch the body.
1. Remove the front wheel arch protector, as needed.
2. Remove the front inner fender (A).
Remove the screws (B, C), and remo
Component Location Index
HOOD OPENER CABLE
Replacement
FUEL FILL DOOR OPENER
Replacement
TAILGATE LATCH
Replacement
FUEL FILL DOOR LATCH
Replacement
FUEL FILL DOOR OPENE
SEE MORE:
This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it.
There are two trip meters: Trip A
and Trip B. Switch between these
displays by pressing the select/reset
knob repeatedly.
Each trip meter works independently,
so you can keep track of two
To listen to XM radio, turn the
ignition switch to the ACCESSORY
(I) or the ON (II) position. Push the
button to turn on the audio
system, and press the ‘‘XM’’ button.
Adjust the volume by turning the
VOL/SELECT knob. The last
channel you listened to will show in
the display.
© 2016-2025 Copyright www.hcrv.net
