Honda CR-V manuals

Honda CR-V: Windshield Wiper

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Windshield Wipers and Washers / Windshield Wiper

1. MIST

1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers

Push the right lever up or down to select a position.

MIST - The wipers run at high speed until you release the lever.

OFF - The wipers are not activated.

INT - The wipers operate every few seconds. At low speed and high speed, the wipers run continuously.

On all models except LX

Vary the delay by turning the adjustment ring. If you turn it to the shortest delay (wipers change to low speed position), the wipers change to low speed operation when the vehicle speed exceeds 12 mph (20 km/h).

The length of the wiper interval is varied automatically according to the vehicle’s speed.

LO - The wipers run at low speed.

HI - The wipers run at high speed.

READ NEXT:

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

SEE MORE:

 Adjust the Seat-Backs

Adjust the driver’s seat-back to a comfortable, upright position, leaving ample space between your chest and the airbag cover in the center of the steering wheel. Passengers with adjustable seatbacks should also adjust their seatback to a comfortable, upright position. Recl

 DLC Circuit Troubleshooting

NOTE: Make sure the HDS and the DLC cable of the HDS is not defective. 1. Turn the ignition switch OFF. 2. Connect the HDS to the DLC. NOTE: Make sure the HDS is properly connected to the DLC. 3. Turn the ignition switch ON (II). and read the HDS. Does the HDS identify the vehicle? YES-Go to ste

© 2016-2025 Copyright www.hcrv.net