Honda CR-V: Side Engine Mount Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the upper torque rod.

4. Remove the ground cable (A), then remove the side
engine mount bracket (B).

5. Remove the side engine mount stiffener (A), then
remove the side engine mount (B).

6. Install the side engine mount, then install the side
engine mount stiffener.
7. Install the side engine mount bracket (A), then
loosely tighten the new bolt and nut (B), and
loosely tighten the bolt (C).

8. Install the ground cable (D).
9. Remove the air cleaner housing assembly.
10. Loosen the transmission mounting bolt and nuts
(A).

11. Raise the lift to full height.
12. Loosen the lower torque rod mounting bolt (A).

13. Lower the vehicle on the lift.
14. Tighten the side engine mount mounting bolts and
nut.

15. Tighten the transmission mounting bolt and nuts.

16. Raise the lift to full height.
17. Tighten the lower torque rod mounting bolt.

18. Lower the vehicle on the lift.
19. Install the air cleaner housing assembly.
20. Install the upper torque rod, then tighten the new
upper torque rod mounting bolts in the numbered
sequence shown.

READ NEXT:
1. Loosen the upper torque rod mounting bolt (A).
2. Remove the air cleaner housing assembly.
3. Remove the powertrain control module (PCM)
cover, then remove the three bolts securing the
PCM.
4. R
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the upper torque rod.
3. Remove the ground cable (A), then remove the side
engine mount bracket (B).
4. Install the sid
Special Tools
Air Pressure Regulator
Valve Guide Reamer, 5.5 mm
Socket, 19 mm
Holder Handle
Adjuster
Locknut Wrench
Stem Seal Driver
VTEC Air Adapter
VTEC Air Stopper
Air Joint Adapter
C
SEE MORE:
Tips and Precautions
Before Troubleshooting
1. Check applicable fuses in the appropriate fuse/relay
box.
2. Check the battery for damage, state of charge, and
clean and tight connections.
NOTICE
Do not quick-charge a battery unless the battery ground cable has been
disconnected, otherwise you w
1. Park the vehicle, and set the
parking brake. Pull the hood
release handle located under the
lower left corner of the dashboard.
The hood will pop up slightly.
2. Reach in between the hood and
the front grille with your fingers.
The hood latch handle is above
the ‘‘H’’ log
© 2016-2025 Copyright www.hcrv.net
