Honda CR-V: Nothing Happens or the Starter Motor Operates Very Slowly

Honda CR-V (2006–2011) Owner's Manual / Taking Care of the Unexpected / If the EngineWon’t Start / Nothing Happens or the Starter Motor Operates Very Slowly

When you turn the ignition switch to the START (III) position, you do not hear the normal noise of the engine trying to start. You may hear a clicking sound, a series of clicks, or nothing at all.

Check these things:

Check the transmission interlock.

The transmission must be in Park or neutral or the starter will not operate.

Turn the ignition switch to the ON (II) position. Turn on the headlights, and check their brightness. If the headlights are very dim or do not come on at all, the battery is discharged. See Jump Starting.

Turn the ignition switch to the START (III) position. If the headlights do not dim, check the condition of the fuses. If the fuses are OK, there is probably something wrong with the electrical circuit for the ignition switch or starter motor. You will need a qualified technician to determine the problem. See Emergency Towing.

If the headlights dim noticeably or go out when you try to start the engine, either the battery is discharged or the connections are corroded. Check the condition of the battery and terminal connections. You can then try jump starting the vehicle from a booster battery.

READ NEXT:

 The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using

 Jump Starting

Although this seems like a simple procedure, you should take several precautions. A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby. Ke

 If the Engine Overheats

The reading of the vehicle’s temperature gauge should stay in the midrange. If it climbs to the red mark, you should determine the reason (hot day, driving up a steep hill, etc.). If the

SEE MORE:

 A/T Gear Position Indicator

Component Location Index A/T GEAR POSITION INDICATOR F-CAN Communication Circuit Troubleshooting Gauge Control Module Self-diagnostic Function Indicator Drive Circuit Check Communication Line Check A/T GEAR POSITION INDICATOR PANEL LIGHT HARNESSReplacement A/T GEAR POSITION INDICATOR PANEL

 Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required Hub dis/assembly tool 07GAF-SD40100 Ball joint remover, 32 mm 07MAC-SL0A102 Ball joint remover, 28 mm 07MAC-SL0A202 Ball joint thread protector, 14 mm 071AF-S3VA000 Attachment, 72 x 75 mm 077 46-0010600 Driver 077 49-0010000 Attachment, 96 mm 07948-SB001

© 2016-2025 Copyright www.hcrv.net