Honda CR-V: MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box.

2. Disconnect under-dash fuse/relay box connectors E, F, S, and T.

NOTE: All connector views are wire side of female terminals.

Honda CR-V. Wipers/Washers

3. Inspect the connector and socket terminals to be sure they are all making good contact.

4. With the connectors still disconnected, make these input tests at the appropriate connector.

Honda CR-V. Wipers/Washers

5. Reconnect the connectors to the under-dash fuse/relay box, and make these input tests at the connectors.

Honda CR-V. Wipers/Washers

READ NEXT:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

 Gauges

Component Location Index GAUGE CONTROL MODULE Self-diagnostic Function Input Test Rewriting the ODO Data and Transferring Smart Maintenance on a New Gauge Control Module Replacement Out

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition s

SEE MORE:

 Information Display

As an incoming call notification, you will see the following display: A notification that there is an incoming call, or HFL is in use, will appear on the navigation screen when the audio system is on. When there is an incoming call, or HFL is in use, ‘‘HFL’’ will appear at

 Doors

Component Location Index-Front Door DOOR CENTER OUTER TRIM DOOR LINING BRACKETS DOOR OUTER MOLDING Replacement DOOR GLASS OUTER WEATHERSTRIP Replacement HINGE DOOR CHECKER DOOR Position Adjustment SPEAKER DOOR WEATHERSTRIP Replacement PLASTIC COVER   DO

© 2016-2025 Copyright www.hcrv.net