Honda CR-V: Front Bumper
Front Bumper Removal/Installation
NOTE:
- Have an assistant help you when removing and installing the front bumper.
- Take care not to scratch the front bumper and body.
- Put on gloves to protect your hands.
1. Remove the front bulkhead cover.
2. Remove the bolts (A) and clips (B, C) securing the front bumper (D).
NOTE: To remove the clips, pry the inner clip up at the edge near the line (E) on its head.
3. Remove the screws (F) and clips (G) securing the front bumper side trim (H).
4. Pull on the front bumper (A) at the wheel arch areas to release it from the hooks (B) on the side spacer (C).
5. With the help of an assistant, while pulling the wheel arch portion away from the side spacer (A), pull the front bumper to release the bumper from the hooks (B) on the center upper beam (C).
6. Remove the front bumper (A).
7. Remove the front bumper absorber (A) from the front bumper beam (B).
8. Install the bumper in the reverse order of removal, and note these items:
- Make sure the front bumper engages the hooks (of both corner upper beams and side spacers) on each side securely.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips and hooks into place securely.
Front Bumper Disassembly/Reassembly
NOTE: Take care not to scratch the front bumper faces.
1. Remove the front bumper.
2. Remove the clips, then separate the upper front bumper face (A) from the lower front bumper face (B).
3. Reassemble the bumper faces in the reverse order of disassembly.
READ NEXT:
Rear Bumper
Rear Bumper Removal/Installation
NOTE:
Have an assistant help you when removing and
installing the rear bumper.
Take care not to scratch the rear bumper and body.
Put on gloves to protect your ha
Hood
Hood Adjustment
1. Remove these items:
Front bulkhead cover
Front fender trim
Cowl cover
2. Slightly loosen each bolt (A).
3. Adjust the hood alignment in this sequence:
Adjust the hood right
Tailgate
Tailgate Adjustment
NOTE:
Have an assistant help you when adjusting the
tailgate.
Take care not to scratch the tailgate, body, and other
related parts.
Put on gloves to protect your hands.
1. R
SEE MORE:
To Play a PC Card
You operate the PC card player with
the same controls used for the radio
and the disc player. To load or play a
card, the ignition switch must be in
the ACCESSORY (I) or ON (II)
position.
The PC card player reads and plays
cards in MP3 or WMA formats.
Depending on the format, the scree
To Play a Disc (In-dash single player)
You operate the in-dash disc player
with the same controls used for the
radio. To load or play discs, the
ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Your vehicle also has a CD changer
that operates with the same
functions as the in-dash disc player.
Do not us
