Honda CR-V manuals

Honda CR-V: CD, DVD, and PC Card Removal/Installation

Honda CR-V (2006–2011) Service Manual / Audio, Navigation, and Telematics / Navigation System / CD, DVD, and PC Card Removal/Installation

If the display will not open, use this procedure to manually open the display and remove the CD, DVD, and/or the PC card.

1. Remove the navigation unit from the vehicle.

2. On the bench, carefully pull the display (A) straight out (about 1/2 inch).

Honda CR-V. Navigation System

3. Fold down the display as shown in the diagram below.

Honda CR-V. Navigation System

4. Push the PC card ,eject button (A) to eject the customer's PC card (if installed). Power is not required for this function.

Honda CR-V. Navigation System

5. Open the plastic cover (B) for the navigation DVD slot. Do not remove the plastic cover.

6. With the display open, temporarily reconnect the unit in the dash (to power it up).

7. Push the CD "eject" button (C), and navigation DVD "eject" button and remove the discs (holding both discs by their edges to avoid fingerprints). To avoid scratches, place the navigation DVD, and customer's CD in a jewel case if available.

8. Close the plastic cover that covers the navigation DVD slot.

9. Close the display by first returning the display to the upward position, and then pushing the entire display straight back into the unit.

10. After installing the new navigation unit, re-insert the navigation DVD, the customer's CD, and PC card.

READ NEXT:

 Navigation Unit Removal/Installation

SRS components are located in this area. Review the SRS component location. Also review the precautions and procedures in the SRS section before doing repairs or service. NOTE: Put on gloves to pro

 Restraints

 Seat Belts

Component Location Index REAR CENTER SEAT BELT REAR CENTER SEAT BELT BUCKLE and LEFT REAR SEAT BELT BUCKLE REAR SEAT BELT FRONT SEAT BELT FRONT SEAT BELT BUCKLES RIGHT FRONT SEAT BELT LOWER A

SEE MORE:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

 Steering Gearbox Overhaul

Exploded View Special Tools Required Cylinder end seal remover attachment 070AF-S7S0100 Valve seal ring sizing tool 07NAG-SR3090A Sleeve seal ring guide 07YAG-S2X0100 Sleeve seal ring sizing tool, 36 mm 07ZAG-S5A0100 Attachment, 28 x 30 mm 07946-1870100 Driver 07749-0010000 Piston seal ri

© 2016-2026 Copyright www.hcrv.net