Honda CR-V: Instrument Panel Brightness

You can change the instrument panel

You can change the instrument panel brightness only when the light switch is on.

Turn the knob on the lower part of the instrument panel to adjust the brightness.

You will hear a beep when maximum or minimum brightness is reached.

To reduce glare at night, the

To reduce glare at night, the instrument panel illumination dims when you turn the light switch to Turning the select/ or Turning the select/. Turning the select/ reset knob fully to the right until you hear a beep will cancel the reduced brightness.

READ NEXT:

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

SEE MORE:

 DTC P0455/P0456: EVAP System Large Leak Detected/Very Small Leak Detected

DTC P0455: EVAP System Large Leak Detected DTC P0456: EVAP System Very Small Leak Detected NOTICE The fuel system is designed to allow specified maximum vacuum and pressure conditions. Do not deviate from the vacuum and pressure tests as indicated in these procedures. Excessive pressure/ vacuum wou

 Keyless/Power Door Locks/Security System

Component Location Index NAVIGATION UNIT or AUDIO UNIT IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver) MICU (Built into the under-dash fuse/relay box) HEADLIGHTS HORN HOOD SWITCH SECURITY INDICATOR UNLOCK BUTTON IGNITION KEY PANIC BUTTON LOCK BUTTON TRANSMITTER IGNITION K

© 2016-2025 Copyright www.hcrv.net