Honda CR-V: Automatic Transmission

READ NEXT:

 Shift Lever Position Indicators

These indicators on the instrument panel show which position the shift lever is in. The ‘‘D’’ indicator comes on for a few seconds when you turn the ignition switch to the ON (II)

 Shifting

To shift from any position, press firmly on the brake pedal and the release button on the side of the shift lever. You cannot shift out of Park when the ignition switch is in the LOCK (0)

 Engine Speed Limiter

If you exceed the maximum speed for the gear you are in, the engine speed will enter into the tachometer’s red zone. If this occurs, you may feel the engine cut in and out. This is caused

SEE MORE:

 DTC P0457: EVAP System Leak Detected/Fuel Fill Cap Loose or Missing

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check the fuel fill cap (the cap must say "Tighten to click"). It should turn 1/4 turn after it's tight, then it clicks. Is the correct fuel fill cap installed a

 Crankshaft Installation

Special Tools Required Driver 077 49-00 10000 Oil seal driver attachment, 96 mm 07ZAD-PNAA.100 1. Check the connecting rod bearing clearance with plastigage. 2. Check the main bearing clearance with plastigage. 3. Install the bearing halves in the engine block and connecting rods. 4. Apply a

© 2016-2025 Copyright www.hcrv.net