Honda CR-V: Reporting Safety Defects (U.S. Vehicles)

Honda CR-V (2006–2011) Owner's Manual / Warranty and Customer Relations / Reporting Safety Defects (U.S. Vehicles)

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Honda Motor Co., Inc.

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign.

However, NHTSA cannot become involved in individual problems between you, your dealer, or American Honda Motor Co., Inc.

To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1-888-327-4236БЮ (TTY: 1-800-424-9153); go to http://www.saf ercar.gov; or write to:
Administrator, NHTSA, 1200 New Jersey Avenue, SE., Washington, DC 20590.

You can also obtain other information about motor vehicle safety from http://www.saf ercar.gov.

READ NEXT:

 AuthorizedManuals

Purchasing Factory Authorized Manuals (U.S. only) The publications shown below can be purchased from Helm Incorporated. You can order by phone or online: - Call Helm Inc. at 1-800-782-4356 (credit

 Honda CR-V (2006–2011) Service Manual

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

SEE MORE:

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remove the boot bands. Be careful not to damage the boot. 3. Make marks (A) on each roller (B) and inboa

 Frame

Under-cowl Panel Replacement NOTE: Take care not to scratch the body. 1. Remove these items: Windshield wiper arms Front fender trim, both sides Cowl covers 2. Remove the bolts and nuts, disconnect the connector (A) and remove the grommet (B), then remove the under-cowl panel (C). 3. Install

© 2016-2026 Copyright www.hcrv.net