Honda CR-V: Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands.
2. Turn the driveshaft by hand, and make sure the splines (E) and joint are not excessively loose.
3. Make sure the driveshaft is not twisted or cracked; if it is, replace it.
Front Driveshaft Removal
1. Raise the vehicle on a lift, and remove the front wheels.
2. Lift up the locking tab (A) on the spindle nut (B), then remove the nut.
3. If you need to remove the left driveshaft, drain the transmission fluid. It is not necessary to drain the transmission fluid when the right driveshaft is removed.
4. Disconnect the driveshaft outboard joint from the front wheel hub using a plastic hammer.
5. Remove the nuts and bolt, then separate the lower arm with a prybar.
6. Pull the knuckle outward, and remove the driveshaft outboard joint from the front wheel hub.
7. Left driveshaft: Pry the inboard joint (A) from the differential case with a prybar. Pull the driveshaft straight out to avoid damaging the oil seal.
Right drives haft: Drive the inboard joint (A) off of the intermediate shaft with a drift and hammer.
Remove the driveshaft as an assembly. Do not pull on the driveshaft (B), because the inboard joint may come apart.
Left driveshaft
Right driveshaft
Boot Band Removal
NOTE: When removing the boot bands, be careful not to damage the boot.
Welded Type
1. Cut the boot band (A), then remove the boot band.
Dpuble Loop Type
1. Lift up the band end (A), then push it into the clip (B), then remove the boot band.
Low Profile Type
1. Pinch the boot band using commercially available boot band pliers (A), then remove the boot band.
Ear Clamp Type
1. Lift up the three tabs (A) with a screwdriver, then remove the boot band.
READ NEXT:
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remov
Boot Band Installation
Special Tools Required
Boot band tool, KD-3191 or equivalent, commercially
available
Boot band pliers, Kent-Moore J-35910 or equivalent,
commercially available
Double Loop Type
1. Fit the boot ends on
Front Driveshaft Reassembly
Exploded View
NOTE: Refer to the Exploded View as needed during
this procedure.
Inboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent
damaging to the inboard boot.
2. Install the inb
SEE MORE:
To Remove Exterior Frost or Ice Fromthe Windows
1. Select
. The system
automatically switches to fresh air
mode and turns on the A/C.
The A/C indicator does not come
on if it was off to start with.
2. Select
.
3. Set the fan and temperature
controls to maximum level.
To clear the windows faster, you can
close the dashboard corner
Introduction
Congratulations! Your selection of a 2010 Honda CR-V was a wise
investment. It will give you years of driving pleasure.
One of the best ways to enhance the enjoyment of your new vehicle is to
read this manual. In it, you will learn how to operate its driving controls and
convenience items. Af
