Honda CR-V: Rear Window Defogger

Component Location Index

Honda CR-V. Rear Window Defogger

Circuit Diagram

Honda CR-V. Rear Window Defogger

Function Test

NOTE:

1. Measure voltage between the positive terminal (A) and body ground with the ignition switch and the defogger switch ON.

There should be battery voltage.

Honda CR-V. Rear Window Defogger

2. Turn the ignition switch OFF, and disconnect the negative terminal (B) from the rear window defogger.

3. Check for continuity between the negative terminal (B) and body ground.

If there is no continuity, check for an open in the wire or poor ground (G602). If there is continuity, go to step 4.

4. Reconnect the negative terminal to the rear window defogger.

5. Turn the ignition switch ON (II) and the rear window defogger switch ON.

6. Touch the voltmeter positive probe to each point on each defogger wire, and the negative probe to the negative terminal.

Defogger Wire Repair

NOTE: To make an effective repair, the broken section must be no longer than 1 in. (25 mm).

1. Lightly rub the area around the broken section (A) with fine steel wool, then clean it with alcohol.

Honda CR-V. Rear Window Defogger

2. Carefully mask above and below the broken portion of the defogger wire (B) with cellophane tape (C).

3. Using a small brush, apply a heavy coat of silver conductive paint (commercially available) (A) extending about 1/8" on both sides of the break.

Allow 25 minutes to dry.

Honda CR-V. Rear Window Defogger

4. Do the function test to confirm that the wire is repaired.

5. Apply a second coat of paint in the same way. Let it dry 3 hours before removing the tape.

READ NEXT:

 Immobilizer System

Component Location Index IMMOBILIZER INDICATOR IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver) UNDER-DASH FUSE/RELAY BOX IMOES UNIT (Built into the MICU) PCM IGNITION KEY TRANSPONDE

 Audio, Navigation, and Telematics

 Audio System

Component Location Index LEFT REAR DOOR SPEAKER AUDIO REMOTE SWITCH (Except LX model) LEFT TWEETER (Except LX model) DRIVER'S DOOR SPEAKER AUDIO UNIT NAVIGATION UNIT RIGHT TWEETER (Except LX

SEE MORE:

 Torque Converter Housing

Mainshaft Bearing and Oil Seal Replacement Special Tools Required Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A Attachment, 62 x 68 mm 07746-0010500 Attachment, 72 x 75 mm 07746-0010600 Driver 07749-0010000 1. Remove the mainshaft bearing and oil seal using the adjustabl

 Door Lower Trim Replacement

NOTE: Take care not to scratch the door. Put on gloves to protect your hands. 1. Remove these items: Door panel, front , rear. Door speaker, front, rear. 2. From the front or the rear door, remove the screw. 3. Using a utility knife, carefully cut the double-sided adhesive tape (A) along th

© 2016-2025 Copyright www.hcrv.net