Honda CR-V: Glove Box Removal/Installation

Honda CR-V (2006–2011) Service Manual / Body / Dashboard / Glove Box Removal/Installation

NOTE: Take care not to scratch the dashboard and related parts.

1. Open the glove box (A), and detach the hook (B) of the glove box damper. While holding the glove box, release the glove box stop (C) on each side from the dashboard by pushing them in.

Honda CR-V. Dashboard

2. Close the glove box (A), then remove the bolts and remove the glove box.

Honda CR-V. Dashboard

3. Install the glove box in the reverse order of removal.

Glove Box Damper Replacement

NOTE:

1. Remove the these items:

2. Detach the clip of the glove box damper (A) by pinching it to release from inside the dashboard, then remove the damper.

Honda CR-V. Dashboard

3. Install the damper in the reverse order of removal.

Glove Box Striker Replacement

NOTE: Take care not to scratch the dashboard and related parts.

1. For some models: Remove the glove box light (A).

Honda CR-V. Dashboard

2. Detach the hook of the glove box damper and release the glove box stop on each side from the dashboard by pushing them inside (see step 1).

3. Remove the screws, then remove the glove box striker (B).

4. Install the striker in the reverse order of removal.

Dashboard Glove Box Cover Removal/Installation

NOTE: Take care not to scratch the dashboard and related parts.

1. Remove the dashboard/steering hanger beam.

2. Remove the steering/steering hanger beam from the dashboard.

3. Remove the screws, then remove the dashboard glove box center cover (A) or the dashboard glove box outer cover (B).

Center

Honda CR-V. Dashboard

Outer

Honda CR-V. Dashboard

4. Install the cover in the reverse order of removal.

READ NEXT:

 Column Cover Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Take care not to scratch the dashboard and relate

 Seats

Component Location Index REAR SEAT Removal/Installation Armrest Removal/Installation Armrest Cover Replacement Right Rear Seat Cover Replacement Left Rear Seat Cover Replacement Right S

 Front Seat

Front Seat Active Head Restraint Inspection NOTE: If the vehicle has been in a collision, always inspect the active head restraints, even if they appear reusable, by doing the following procedure. Res

SEE MORE:

 DTC P0752: Shift Solenoid Valve A Stuck ON

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Warm up the engine to normal operating temperature (the radiator fan comes on). 2. Make sure that the transmission is filled to the proper level, and check for fluid

 Automatic Transmission

Special Tools 07HAE-PL50101 may also be used to substitute one of 07LAE-PX40100. Mainshaft Holder Attachment, 78 x 90 mm Clutch Spring Compressor Bolt Assembly Holder Handle Oil Seal Driver Attachment Attachment, 40 x 50 mm Clutch spring Compressor Attachment Bearing Installer Attachment

© 2016-2025 Copyright www.hcrv.net