Honda CR-V: Catalytic Converter System

Component Location Index

Honda CR-V. Catalytic Converter System

Honda CR-V. Catalytic Converter System

DTC Troubleshooting

DTC P0420: Catalyst System Efficiency Below Threshold

NOTE:

1. Turn the ignition switch ON (II).

2. Clear the DTC with the HDS.

3. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle.

4. Test-drive under these conditions:

5. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate EXECUTING? YES-Go to step 6.

NO-Go to step 4 and recheck.

6. Continue test driving until a result comes on.

7. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate FAILED? YES-Go to step 8.

NO-If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen indicates EXECUTING, keep driving until a result comes on. If the screen indicates OUT OF CONDITION, go to step 4 and recheck.

8. Turn the ignition switch OFF.

9. Replace the TWC.

10. Turn the ignition switch ON (II).

11. Reset the PCM with the HDS.

12. Do the PCM idle learn procedure.

13. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until the radiator fan comes on, then let it idle.

14. Test-drive for about 10 minutes, varying the vehicle speed.

15. Check the CATA MONITOR CONDITION in the DATA LIST with the HDS.

Is the temperature OK? YES-Go to step 16.

NO-Go to step 13 and recheck.

16. Test-drive under these conditions:

17. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate EXECUTING? YES-Go to step 18.

NO-Go to step 16 and recheck.

18. Continue test-driving until a result comes on.

19. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P0420 indicated? YES-Check the fuel quality, then go to step 1.

NO-Go to step 20.

20. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate PASSED? YES-Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in step 19, go to the indicated DTC's troubleshooting.

NO-If the screen indicates FAILED, check the fuel quality, then go to step 1. If the screen indicates EXECUTING, keep driving until a result comes on. If the screen indicates OUT OF CONDITION, go to step 13.

Catalytic Converter Removal/Installation

1. Lift the vehicle, and support it with jackstands.

2. Remove the A/F sensor (Sensor 1).

3. Remove the secondary HO2S (Sensor 2).

4. Remove the bolts (A), and the nuts (B).

Honda CR-V. Catalytic Converter System

5. Remove the bolts (C), and the covers (D).

6. Remove the TWC (E).

7. Install the parts in the reverse order of removal with new gaskets (F).

READ NEXT:

 EGR System

Component Location Index EXHAUST GAS RECIRCULATION (EGR) VALVE POWERTRAIN CONTROL MODULE (PCM) EXHAUST GAS RECIRCULATION (EGR) PLATE DTC Troubleshooting DTC P0401: EGR Insufficient Flow NOT

 PCV System

Component Location Index PCV VALVE PCV Valve Inspection 1. Check the PCV valve (A), hoses (B), and connections for leaks or restrictions. 2. At idle, make sure there is a clicking sound from t

 EVAP System

Component Location Index EVAPORATIVE EMISSION (EVAP) CANISTER PURGE VALVE Replacement POWERTRAIN CONTROL MODULE (PCM) General Troubleshooting Information Replacement

SEE MORE:

 Text Data Display Function

Each time you press the TITLE button, the display shows you the text, if the disc was recorded with text data. You can see the album, artist, and track name in the display. If a disc is recorded in MP3 or WMA, you can see the folder and file name, and the artist, album, and track tag.

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until you release the lever. OFF - The wipers are not activated. INT - The wipers operate every few s

© 2016-2025 Copyright www.hcrv.net