Honda CR-V manuals

Honda CR-V: Using the Cruise Control

Honda CR-V (2006–2011) Owner's Manual / Features / Cruise Control / Using the Cruise Control

1. Push the CRUISE button on the

1. Push the CRUISE button on the steering wheel. The CRUISE MAIN indicator on the instrument panel comes on.

The cruise control systemcan be left on, even when it is not in use.

2. Accelerate to the desired cruising speed above 25 mph (40 km/h).

3. Press and release the SET/ DECEL button on the steering wheel. The CRUISE CONTROL indicator on the instrument panel comes on to show the system is now activated.

Cruise control may not hold the set speed when you are going up and down hills. If your vehicle speed increases going down a hill, use the brakes to slow down. This will cancel the cruise control. To resume the set speed, press the RES/ACCEL button.

The CRUISE CONTROL indicator on the instrument panel will come back on.

READ NEXT:

 Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. To increase the speed in ver

 Canceling Cruise Control

You can cancel cruise control in any of these ways: Tap the brake pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel.

 Resuming the Set Speed

When you push the CANCEL button, or tap the brake pedal, the system remembers the previously set speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and relea

SEE MORE:

 Horns

Component Location Index HORN HORN SWITCH HORN RELAY CIRCUIT (Built into the MICU) CABLE REEL UNDER-DASH FUSE/RELAY BOX Circuit Diagram Horn Switch Test 1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 20P connector (A) from the cable reel (B). 3. Usin

 Removing Discs from the In-dash Disc Changer

To remove the disc currently in play, press the eject button. When a disc is removed from a slot, the system automatically begins the load sequence so you can load another disc in that position. If you do not remove the disc from the changer within 10 seconds, the disc will reload in

© 2016-2025 Copyright www.hcrv.net