Honda CR-V: Side Engine Mount Replacement

1. Support the engine with a jack and wood block under the oil pan.

2. Remove the power steering (P/S) fluid reservoir from the holder.

3. Remove the upper torque rod.

Honda CR-V. Side Engine Mount Replacement

4. Remove the ground cable (A), then remove the side engine mount bracket (B).

Honda CR-V. Side Engine Mount Replacement

5. Remove the side engine mount stiffener (A), then remove the side engine mount (B).

Honda CR-V. Side Engine Mount Replacement

6. Install the side engine mount, then install the side engine mount stiffener.

7. Install the side engine mount bracket (A), then loosely tighten the new bolt and nut (B), and loosely tighten the bolt (C).

Honda CR-V. Side Engine Mount Replacement

8. Install the ground cable (D).

9. Remove the air cleaner housing assembly.

10. Loosen the transmission mounting bolt and nuts (A).

Honda CR-V. Side Engine Mount Replacement

11. Raise the lift to full height.

12. Loosen the lower torque rod mounting bolt (A).

Honda CR-V. Side Engine Mount Replacement

13. Lower the vehicle on the lift.

14. Tighten the side engine mount mounting bolts and nut.

Honda CR-V. Side Engine Mount Replacement

15. Tighten the transmission mounting bolt and nuts.

Honda CR-V. Side Engine Mount Replacement

16. Raise the lift to full height.

17. Tighten the lower torque rod mounting bolt.

Honda CR-V. Side Engine Mount Replacement

18. Lower the vehicle on the lift.

19. Install the air cleaner housing assembly.

20. Install the upper torque rod, then tighten the new upper torque rod mounting bolts in the numbered sequence shown.

Honda CR-V. Side Engine Mount Replacement

READ NEXT:

 Transmission Mount Replacement

1. Loosen the upper torque rod mounting bolt (A). 2. Remove the air cleaner housing assembly. 3. Remove the powertrain control module (PCM) cover, then remove the three bolts securing the PCM. 4. R

 Side Engine Mount Bracket Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the upper torque rod. 3. Remove the ground cable (A), then remove the side engine mount bracket (B). 4. Install the sid

 Cylinder Head

Special Tools Air Pressure Regulator Valve Guide Reamer, 5.5 mm Socket, 19 mm Holder Handle Adjuster Locknut Wrench Stem Seal Driver VTEC Air Adapter VTEC Air Stopper Air Joint Adapter C

SEE MORE:

 Driving Guidelines

Your vehicle has higher ground clearance that allows you to travel over bumps, obstacles, and rough terrain. It also provides good visibility so you can anticipate problems earlier. Because your vehicle rides higher off the ground, it has a high center of gravity that can cause it to

 Tire Service Life

The service life of your tires is dependent on many factors, including, but not limited to, driving habits, road conditions, vehicle loading, inflation pressure, maintenance history, speed, and environmental conditions (even when the tires are not in use). In addition to your regular

© 2016-2025 Copyright www.hcrv.net