Honda CR-V: Mode Control
Use the mode control buttons to select the vents air flows from. Some air will flow from the dashboard corner vents in all modes.
Air flows from the center and corner vents in the dashboard.
Airflow is divided between the vents in the dashboard and the floor vents.
Air flows from the floor vents.
When you select
, the system
automatically switches to fresh air
mode. If you switch the mode from
or
to
, the system
keeps the A/C on. The A/C
indicator will not come on if it was
off to start with.
To turn off the A/C, press the A/C button to illuminate the indicator, then press it again to turn off the A/C.
When you switch to
or
mode from
, the A/C
turns off. But if it was on to start
with, the A/C stays on.
Airflow is divided between
the floor vents and defroster vents at
the base of the windshield.
Air flows from the defroster
vents at the base of the windshield.
When you select
or
,
the system automatically switches to
fresh air mode and turns on the A/C.
You cannot turn the A/C off in this mode.
READ NEXT:
Ventilation
The flow-through ventilation system
draws in outside air, circulates it
through the interior, then discharges
it through vents near the tailgate.
1. Set the temperature to the lower
limit.
2
Using the Heater
The heater uses engine coolant to
warm the air. If the engine is cold, it
will be several minutes before you
feel warm air coming from the
system.
1. Select
.
When you select
, the system
Using the A/C
Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge. If it moves near the red zone,
turn off the A/C until the gauge
reading returns to normal.
1.
SEE MORE:
To Play a USB Flash Memory Device
This audio system can operate the
audio files on a USB flash memory
device with the same controls used
for the in-dash disc changer. To play
a USB flash memory device, connect
it to the USB adapter cable in the
upper glove box, then press the CD/
AUX or AUX button.
The audio system re
Shifting
To shift from any position, press
firmly on the brake pedal and the
release button on the side of the
shift lever. You cannot shift out of
Park when the ignition switch is in
the LOCK (0) or ACCESSORY (I)
position.
Park (P) - This position mechanically
locks the transmission. Use
