Honda CR-V: Daytime Running Lights

With the headlight switch in the off or the high beam position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II) position and release the parking brake. They remain on until you turn the ignition switch off, even if you set the parking brake.

The headlights revert to normal operation when you turn them on with the switch.

READ NEXT:

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

SEE MORE:

 Hydraulic Controls

Valve Bodies The valve body includes the main valve body, the regulator valve body, and the servo body. The ATF pump is driven by splines on the left end of the torque converter which is attached to the engine. Fluid flows through the regulator valve to maintain specified pressure through the main

 Driveline/Axle

Special Tools Oil Seal Driver Attachment, 52 x 55 mm Half Shaft Base Threaded Adapter, 24 x 1.5 mm Threaded Adapter, 26 x 1.5 mm Attachment, 35 mm I.D. Driver Inner Handle, 30 mm Oil Seal Driver Component Location Index BOOT BAND Removal Installation INTERMEDIATE SHAFT Rem

© 2016-2025 Copyright www.hcrv.net