Honda CR-V: Compass Calibration

If you see ‘‘- -’’ in the direction
display when you turn the ignition
switch to the ON (II) position, the
compass is self-calibrating.
The compass may need to be
manually calibrated after exposure to
a strong magnetic field. If the
compass display changes to ‘‘- -’’
and the calibrate indicator blinks, or
the display does not show any
direction and the compass is not selfcalibrating,
do the following.
1. Drive the vehicle slowly in three
complete circles.
NOTE: Do this procedure in an open area, away from buildings, power
lines, and other vehicles.
2. When the display goes from
‘‘- -’’ or blank to an actual
heading, the unit is calibrated and
the display returns to normal.
READ NEXT:
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
SEE MORE:
Special Tools Required
Valve spring compressor attachment 07757-PJ1010A
Identify the valves and valve springs as they are
removed so that each item can be reinstalled in its
original position.
1. Remove the cylinder head.
2. Using an appropriate-sized socket (A) and plastic
mallet (B), lightly tap
VSA Modulator-control Unit Inputs and Outputs for 46P Connector
System Outline
This system is composed of the VSA modulator-control unit, the wheel sensors,
the steering angle sensor, and the
yaw rate-lateral acceleration sensor, and the system indicators in the gauge
control module. The VSA mo
© 2016-2025 Copyright www.hcrv.net
