Honda CR-V: Automatic Seat Belt Tensioners

For added protection, the front seat

For added protection, the front seat belts are equipped with automatic seat belt tensioners. When activated, the tensioners immediately tighten the belts to help hold the driver and a front passenger in position.

The tensioners are designed to activate in any collision severe enough to cause the front airbags to deploy, or if a sensor detects your vehicle is about to roll over.

The tensioners can also be activated during a collision in which the front airbags do not deploy. In this case, the airbags would not be needed, but the extra tension in the seat belt could be helpful.

When the tensioners are activated, the seat belts will remain tight until they are unbuckled.

READ NEXT:

 Seat Belt Maintenance

For safety, you should check the condition of your seat belts regularly. Pull each belt out fully, and look for frays, cuts, burns, and wear. Check that the latches work smoothly and the belt

 Additional Information About Your Airbags

 Airbag System Components

Airbag System Components Your airbag system includes: Two SRS (supplemental restraint system) front airbags. The driver’s airbag is stored in the center of the steering wheel; the fr

SEE MORE:

 Interior Trim

Component Location Index TAILGATE SIDE TRIM Removal/Installation TAILGATE UPPER TRIM Removal/Installation QUARTER PILLAR GLASS TRIM Removal/Installation REAR DOOR OPENING SEAL Removal/Installation B-PILLAR UPPER TRIM Removal/Installation FRONT DOOR OPENING SEA

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until

© 2016-2025 Copyright www.hcrv.net