Honda CR-V manuals

Honda CR-V: Windshield Wiper

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Windshield Wipers and Washers / Windshield Wiper

1. MIST

1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers

Push the right lever up or down to select a position.

MIST - The wipers run at high speed until you release the lever.

OFF - The wipers are not activated.

INT - The wipers operate every few seconds. At low speed and high speed, the wipers run continuously.

On all models except LX

Vary the delay by turning the adjustment ring. If you turn it to the shortest delay (wipers change to low speed position), the wipers change to low speed operation when the vehicle speed exceeds 12 mph (20 km/h).

The length of the wiper interval is varied automatically according to the vehicle’s speed.

LO - The wipers run at low speed.

HI - The wipers run at high speed.

READ NEXT:

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

SEE MORE:

 The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using a properly coded key? An improperly coded key will cause the immobilizer system indicator in t

 Self-diagnostic Function

Without Navigation The audio system has a self-diagnostic function. To run the self-diagnostic function, do the following: How to check for audio system condition NOTE: The audio unit must be in the code enter screen before doing the self-diagnostic function. 1. Turn the ignition switch to the AC

© 2016-2025 Copyright www.hcrv.net